Hello Ketilo
In Radasm3 is a missing function
If i use Radasm reseditor adn set controls send to back or send to front works fine
after i reload my project is it wrong i must new set the controls back or front.
I have test Radasm2 this works
A other test in radasm 3 change i controls the Rc file manuelly up IDC_button
#define IDC_BTN2 1001
#define IDC_GRP2 1002
#define IDC_GRP2 1002
#define IDC_BTN2 1001
This works,
Is this a Bug?
Hi
No, it's not a bug. Send to back / Bring to front solves a design problem when controls overlap each other.
To permanently change the Z order, set the controls tabindex.
KetilO
Thanks for you reply
QuoteTo permanently change the Z order, set the controls tabindex.
Mean you the tabindex number of the control?
I have try it an after i reload my project is the control what i have Send to back again Front
In Radasm2 change you the position of control Id´s
from
#define IDC_BTN2 1001
#define IDC_GRP2 1002
to
#define IDC_GRP2 1002
#define IDC_BTN2 1001
This problem is only i reload my Project in Radasm3